How to fix an uneven stain on refinished wood floors.
First coat of floor stain uneven.
I waited a week before i put the first coat of satin oil polyurethane pro finisher by parks on the floor last night.
Uneven rough and blotchy first coats troubleshooting.
My first coats of waterlox original sealer finish look uneven rough and blotchy is this normal a.
Leopard looking very blotchy and very uneven.
Every thing was going fine until today when i started staining the the large mop boards.
Should i proceed and lightly sand and put on second coat of polyurethane.
The stain came out beautiful.
Waterlox original tung oil finishes are penetrating oil finishes.
Hardwood floors in a home create charm style and resale value with very little maintenance.
Rest assured that this is completely normal for your early coat s of waterlox original tung oil finishes.
They are three piece total for the floor boards.
This morning the wood floor looks blotchy.
After the finish dries lightly roughen it in the direction of the grain using 0000 steel wool to provide scratches where pigment particles in the glaze can catch.
The color coats of gel stain will then go on like a toning glaze all on the surface.
That s any thick stain applied over a film finish covering the blotched stain.
Begin by applying a full strength sealer coat of the same finish you ll use for your top coats.
Some areas of wood are more porous than others and end grain never stains to match the face.
Applying polyurethane in even coats is a crucial though not always simple task.
An effective way to seal wood for even gel stain application is to use the lightest available color of gel stain as a first coat.
If your stain looks blotchy or uneven on your floors it was probably caused by poor application technique or poor wood preparation.
If your floors have not yet been coated with lacquer or varnish.
Hi i am currently refinishing all my woodwork in a spare bedroom on the first floor.
To try to correct a staining mishap you can always just start from the beginning with sanding or you can try your hand with a gel stain.
Occasionally however you need to refinish the.
Typically two to three coats are used with sanding in between coats to even them out.
A woodworker applies his first coat of varnish.